For any program:
Load tape
Proper screens: on printout;
add REC, ERR
Single Dish:
Phased Array
-
Record RMS every hour or so
(on a calibration source it should be no more than 10). In observe log
make note:
"Array phasing with # °
RMS"
-
Reference antenna will show
all IF's as 0 in F display. The other antennas should all be about the
same and a low value.
-
If one antenna is not phasing
(has amplitude of 30+ more than others), first try moving it off source
then back on. If it will still not phase, take it out of array
-
To bring antenna back into array,
manually command it close to the current source, then use
Check VLBI materials remotely:
In bashee window, type
% rlogin zia -l vlaops
will prompt for password
: #Joan'sAngels
Change directory:
% cd /home/aspen6/astronomy/mmmyy/"program
name"
Look for following extensions:
__________sch.y
__________crd.y
To get Observe file:
% mail observe <
_______obs.y
This will mail the file
to us.
To print:
% lpr -Pvla-hpd filename
To logoff:
% lo |