Park array

Shutdown Modcomps
At main console:
SYS1>  HALT
SYS1>  SYS2
SYS2>  HALT

(Reload firmware
(On module BOSS:
(open door
(push red button)

Reload OS
At main console type:
CF OBSERVE
When prompted, on Boss terminal enter
H,,12
(Will sometimes get message "IPS Device error, status=0001"; just enter H,,12 command again)
It will take a bit for the software to load
Wait for following message to appear: "netdown program completed"
At Monty terminal type:
H,,12
Software will load
Final message:
BOOT OF OBSERVING SYSTEM COMPLETE
 

Reset OP3
ctrl+a
run bat
AOI
NOTE: After reboot, antennas come back in "use" state. Make sure any antenna being serviced either has E-stop on or immediately put in "take"
Point array using SM or VL overlay

Tape Online
Put tape back online before getting to source.
$  JOB
$  TAPE START (1) or (2)

Spectre Check
Make sure DELAYS and CC start correctly
If they don't, do the following:
?????????
ctrl+a
/IV/B
/DELAYS/ACT,,M
??????????????